Laying Solid Oak Flooring Onto Floorboards

However most standard floor joists are around 400mm apart so it can be difficult to attach your boards securely to the existing joist.

Laying solid oak flooring onto floorboards.

It is also advised that long length boards 6ft or 1 83m are used. Traditionally solid oak flooring was laid by simply sending a nail straight through surface of the boards at even spacing into the floor joists below. Starting in one corner of the room spread in excess of 2 board widths of adhesive along the starting wall sub floor using a 3mm toothed trowel. Look to buy hardwood floor boards that have a thickness of around 19mm to 20mm a 18mm thickness is required for a load bearing floor.

When you are laying a solid timber floor it is best to lay it using a fixed method as opposed to floating commonly used for engineered boards. Nowadays thanks to the introduction of tongue and grooved boards what is known as secret nailing or screwing is the preferred method. The nails or screws should be approximately 300mm apart to offer optimum stability. All of that said if you do decide to go ahead and lay your hardwood flooring straight to your joists here s a few helpful pointers.

Installing solid wood flooring onto concrete use a flexible wood to concrete adhesives such as laybond or soudal polymer. Either solid wood flooring or engineered wood flooring can be laid directly onto joists if the planks are at least 18mm thick. This is because solid wood flooring has a higher tendency towards movement and needs to be fixed to the subfloor to avoid problems in the future. Solid hardwood boards need to be attached to the base every 200 300mm.

Countersink all the nails. Seat the end tongue and groove flooring into each other and push the two boards together for a tight seam. When installing a solid wood floor each plank should be fixed down directly onto the existing wooden floor boards by either secret nailing or secret screwing. Make sure your wood flooring is at least 18mm thick.

Before laying the floor. Make sure the centre point of the first joist is not more than 450mm away from the centre point of the next joist the term often used for this is that the.