The water could be coming from the tub was getting off balance and it is leaking from underneath possibly along the tub drive shaft or from either the drain or recirculating tub.
Lf blinking on cabrio washer and floor soaked with water.
Check the screens on the water supply lines and the water inlet valve for blockage.
I have a whirlpool cabrio washer about a year old.
The washing machine is unable to recognize that the lid is shut and locked.
Whirlpool washing machine.
Is the water supply connected and turned on.
Leave unplugged for about 10 minutes and it will restart after plugging in and pressing start button.
Control knob lights and timer flashing.
Make sure the water supply to the washer is turned on and has pressure.
Cabrio washer stops at start of rinse spin after water is nearly drained.
The washing machine unable to recognize that the lid is shut and locked.
Du f83 door unlock failure the use of unnecessary force has been used on the door.
Leaks when the washer is filling initially during the wash when it is time to fill up to rinse the load.
Racekings we would need to know the exact model of your washer.
Are hose screens plugged.
The washer would begin to soak the clothes right after the spin cycle and then go through the entire wash cycle once again.
My cabrio leaks water at the bottom of the washer to the back of it.
F1 f60 69 primary control failure.
Lf f30 long fill.
When i run a wash cycle it gets stuck in constant loop of wash cycles going on and on.
Depending on the load it could be a little water sometimes quite a bit enough to run to the basement drain right by washer.
Make sure the washer is not filling and draining at the same time if so check your drain hose and insure that its not vapor locked.
Is water entering the tub.
Lf flashes when the water level does not change for a period of time after the valves are turned on or when water has left the drum but the control panel does not detect a water level change.
To stop this how to reset a whirlpool cabrio washing machine read more.